The hazards of using rusty transformer silicon steel sheets!


Release time:

2024-10-15

When introducing the raw materials used in our transformers, we emphasize that Leilang Electric uses brand new silicon steel sheets as core materials. If it is not a brand new silicon steel sheet, the probability of rust will be greatly increased, and the following safety hazards will occur during use:

When introducing the raw materials used in our transformers, we emphasize that Leilang Electric uses brand new silicon steel sheets as core materials. If it is not a brand new silicon steel sheet, the probability of rust will be greatly increased, and the following safety hazards will occur during use:

Short circuit between sheets: After the transformer is rusted, the rust between the sheets will cause a short circuit, increase the loss of the core, and reduce the operating efficiency of the transformer;

Heating of the core: The short circuit between sheets caused by rust will cause the core to heat up, and long-term overheating will affect the insulation performance of the transformer and shorten its service life;

Decrease in magnetic conductivity: Rusting of silicon steel sheets will also affect the magnetic conductivity of the transformer, and the magnetic flux will not meet expectations, affecting the normal operation of the transformer;

Increase in loss: The loss of the transformer includes hysteresis loss and eddy current loss. Rusting may aggravate these two losses, and the induced current generated in the core will increase, thereby increasing heating and energy loss.

It can be seen that rusting of transformer silicon steel sheets is a more serious fault. To avoid this problem, we recommend that you conduct an on-site inspection of the transformer manufacturer to see if its raw materials are brand new silicon steel sheets; during transformer manufacturing, perform varnishing to extend the life of the silicon steel sheets and prevent them from rusting; during later use and maintenance, perform proper maintenance and care to prevent problems before they occur!

Leilang Electric uses qualified standard enameled wire and brand new silicon steel sheet materials to manufacture electrical products, and has certification certificates issued by relevant institutions. A formal transformer manufacturing company with reliable quality and strong manufacturing, welcome to come for on-site inspection and comparison!

Related news

undefined

undefined